Minuteman E Ride 21 - Manual (Page 42)

5-14
5.12 CHECKING/REPLACING THE FUSES
1. Ascertain that the wash-and-dry machine cannot
move autonomously.
2. Rotate the ignition key on “0” and extract it.
3. Disconnect the connector from the batteries, by
acting as described further down.
Remove the left pin (1, Figure 5-14), then rotate it by
half turn, and block it in the removed position.
Remove the right pin (2, Figure 5-14), then remove
the battery holder case (3) by using the handles (4).
Disconnect the connector of the batteries (5).
4. Raise the cover (5, Figure 5-15), remove the panel
(1) by seizing it on the hold (3) and raising it to
disengage it from the retainers (4). Close the cover
(5).
5. Check / replace the fuses:
–
10A Fuse for protecting auxiliary services (2,
Figure 5-15)
6. Place the panel into its seat (1, Figure 5-15) and
engage the retainers (4).
7. Connect the connector of the batteries (5, Figure 5-
14).
8. Replace the batteries case to its seat (3, Figure 5-14)
and engage it to the retainer (2) and retainer (1) after
unblocking it.
5.13 ASSEMBLY-DISASSEMBLY OF THE
S
Q UEEGEE
Disassembly
1. Ascertain that the wash-and-dry machine cannot
move autonomously.
2. Rotate the ignition key on “0” and extract it.
3. By acting of the left side of the wash-and-dry
machine, with the squeegee in raised position, move
slightly the squeegee outwards (1, Figure 5-13), then
loosen its fastening knob (2).
4. Disconnect the suction pipe (3, Figure 5-13) from the
squeegee.
5. Remove the squeegee (1).
Assembly
6. Assemble in the reverse order with respect to
disassembly
Figure 5-13
1 2
3