Minuteman E Ride 21 - Manual (Page 31)

5-3
5.3 CHECKING/SUBSTITUTION OF THE
SQUEEGEE RUBBERS
1. Disassemble and clean the squeegee, by operating
as described in the specific paragraph.
2. Check that the front rubber (1, Figure 5-2) and the
rear rubber (2), are whole and are without cuts and
tears, otherwise substitute them, as described below.
Check also that the front edge (3) of the rear rubber
(2) is not worn out; otherwise turn upside-down this
rubber, by bringing in its place one of the other three
edges, if still whole. Should also the other three
edges be worn out, substitute the rubber, by
operating as described below:
–
Substitute (or turn upside-down) the rear rubber
(2, Figure 5-2) after having released the stop
(4), unhooked the eccentric (5), and removed
the stop band (7) by releasing them from the
dowels with nut (6); finally, refit the rubber by
operating in reverse order with respect to the
removal.
– Substitute the front rubber (1, Figure 5-2) after
having unscrewed the nuts (8) and removed the
stop band (9); finally, refit la rubber by operating
in reverse order with respect to the removal.
3. Refit the squeegee by operating as described in the
specific paragraph.
4. If necessary, carry out the height Adjustment of the
squeegee by operating as described in the following
paragraph.
Figure 5-2
3
6
7
5
7 5
4
6
8
2
9 1