Setting the receiver ctcss/dcs (r-cdc), Setting the transmitting ctcss/dcs (t-cdc), Selecting the frequency step – MIDLAND CT710 - 2014 User Manual
Page 53
CT710 Instruction Guide
| 23
The CTCSS tones available are 50, while DCS codes are 105I and 105N.
Procedure:
Press
MENU
and
#T-R
keys, the display will show
“016 C-CDC?”
.
Press
ENTER
and turn the encoder to select desired CTCSS (OFF-254.1).
Press
*
to switch CTCSS and DCS. The DCS range is OFF-D754N.
Press
ENTER
to confirm and
VFO/MR
to exit.
Setting the receiver CTCSS/DCS (R-CDC)
Press
MENU
and turn the encoder to select
“017 R-CDC?”
.
Press
ENTER
and turn the encoder to select desired CTCSS (OFF-254.1).
Press
*
to switch CTCSS and DCS. The DCS range is OFF-D754N.
Press
ENTER
to confirm and
VFO/MR
to exit.
Setting the transmitting CTCSS/DCS (T-CDC)
Press
MENU
and turn the encoder to select
“018 T-CDC?”
.
Press
ENTER
and turn the encoder to select desired CTCSS (OFF-254.1).
Press
*
to switch CTCSS and DCS. The DCS range is OFF-D754N.
Press
ENTER
to confirm and
VFO/MR
to exit.
Note:
when you set the Menu of DCS codes, press [#] and you can select OFF-
D754I (Inverted).
+/- Frequency shift direction (for communications
through repeaters)
This function can only be enabled in VFO (frequency) mode.
In frequency mode, press
MENU
and
*
: the display will show
“019
S-D?
”
.
Press
ENTER
and the display shows
“S-D 0”
(same frequency); turn the
encoder and you can select
“S-D+”
or
“S-D-“
. Press
ENTER
to confirm
and
VFO/MR
to exit.
Selecting the Frequency Step
This function can only be enabled in VFO (frequency) mode.
In frequency mode, press
MENU
and turn the encoder to item 20:
“020
STEP?
”
will be displayed.
Press
ENTER
and turn the encoder to select the frequency stepping: 5k,
10k, 6.25k, 12.5k, 25k. Press
ENTER
to confirm and
VFO/MR
to exit.