MotorVac CarbonClean1000 - Manual (Page 13)

    2012 MotorVac, Inc. 12
Vehicle Connection Procedure
1. With the vehicle’s engine off remove the vehicle’s gas cap.
2. Connect air supply hose to air inlet adapter on the back of the CarbonClean
1000.
3. Turn pressure regulator counterclockwise until the machine pressure gauge
reads zero.
4. Connect the CarbonClean1000 to the vehicle. Refer to application guide for
instructions on how to properly connect to the vehicle being serviced.
(
www.motorvacapplicationguide.com )
5. Go to next service procedure step based on connection method.
Flammable Liquid can squirt out of pressurized lines when connecting or
disconnecting.
Wear Safety goggles.
Obtain ZERO pressure before connecting or disconnecting any fuel lines or adaptors.
Wear chemical resistant gloves when connecting or disconnecting fittings and
adaptors.
Wrap shop towel around pressure fittings and adaptors when disconnecting.
Avoid exposure to flames, sparks, hot engine parts, and other ignition sources.
Explosion or flame or exposure to flammable liquid and vapors can cause injury.