MotorVac CarbonClean1000 - Manual (Page 21)

    2012 MotorVac, Inc. 20
3. Remove dust cap. Attach can by screwing it to the inlet port. Refer to directions
on the can. Observe the sight glass below the inlet port to ensure the can fully
empties into the machine. Leave can on during service.
4. Connect the CarbonClean 1000 battery terminals to the car’s battery. The power
and ready LEDs should be illuminated.
5. Set the pressure on the CarbonClean 1000 by turning the pressure regulator
clockwise slowly until the MACHINE PRESSURE GAUGE reads 5-10 psi below the
pressure noted in the application guide.
CAUTION: Refer to application guide for vehicle specific instructions.
6. Disable the fuel pump. See application guide for vehicle specific instructions.
7. When the buzzer sounds and the amber Service Complete LED is illuminated the
treatment is complete. Shut off the engine. Disconnect the unit’s battery clips.
Turn air pressure regulator counter-clockwise until the machine pressure gauge
reads zero.
CAUTION: Relieve pressure in the fuel line before disconnecting adapters.
NOTE: Use only approved
chemicals
Use of non approved chemicals
can be a serious fire/explosion
hazard
Do not leave machine
unattended during service.