Diamond Products CC155 - Manual (Page 13)

CC155 Green Concrete Saw Manual 9
Operating the CC155
Handlebars
The handlebars help the operator guide and
maneuver the saw.
Figure 4: Handlebars
Adjusting the Handlebars
1. Loosen the handlebar lock knob.
2. Push down or pull up on the handlebar grips to
adjust the handlebars to the desired height.
3. Retighten the handlebar lock knob to secure.
4. Adjust the handlebar height as necessary.
Front Pointer
The front pointer helps the operator follow the
cutting line.
Adjusting the Front Pointer
1. Lower the front pointer to the ground.
2. Divide a 6–8 ft piece of string in half.
3. Place the looped end of string into a gullet on
the backside of the blade.
4. Place one string line up against the backside of
the blade and one string line up against the
front side of the blade. Holding the string ends
in one hand, tension the lines out toward the
pointer wheel.
Figure 5: String Line and Blade
5. Adjust the hex nuts and guide wheel to place
the wheel between the tensioned string lines.
Figure 6: Guide Wheel
6. Lift the front pointer off the ground when the
cutting task is complete.