Diamond Products CC155 - Manual (Page 24)

20
Daily Maintenance Task Chart
Table 4: Daily Maintenance Task Chart
Date
      
1.
Lubricate blade shaft bearing
grease fittings.
2.
Inspect skip plate for
damages and clean, repair,
or replace as necessary.
3.
Level skip plate mounting
flange as necessary.
4.
Inspect belts after first four
hours of use, and then daily
for tension and wear.
Replace or re-tension as
necessary.
5. Inspect saw for damages.
6. Tighten loose nuts and bolts.
7.
Clean air filter weekly (see
engine manual).
8.
Check fuel level and fill as
necessary.
9.
Check engine oil level and fill
as necessary (see engine
manual).
10. Wipe down saw exterior.
11.
Wipe down engine exterior
and guards.
12. Look for fluid leaks.
Refer to engine manual for daily engine maintenance tasks.