Diamond Products CC7074 - Manual (Page 7)

4
 Drain the fuel tank and fuel lines when storing the
saw for longer periods of time. Refer to the engine
manual for additional recommendations.
Engine Safety
 Refer to the engine manual as the primary source
for engine safety.
 Always know how to turn off the engine quickly for
emergency purposes.
 Make sure the saw is in neutral when starting the
engine.
 Fill the fuel tank and check the oil level prior to
starting the engine.
 Keep all body parts away from
rotating saw parts with the engine
running.
 DO NOT start the engine without the air filter(s)
installed.
 DO NOT allow dust to enter the air intake tube when
cleaning/replacing air filter(s).
 Replace damaged components immediately that
may allow dust to enter the engine.
 DO NOT leave the engine running unattended.
 Always operate the saw in well-ventilated
areas. Concentrated engine exhaust can
cause loss of consciousness and/or death.
 DO NOT touch the engine/muffler assembly with the
engine running, and always let them cool down prior
to touching or servicing the saw.
 Handle hot oil carefully when changing the oil.
 Let the engine cool prior to removing pressurized
caps (applicable models).
 DO NOT use any starter substances or starter fluids
(e.g., starter fluid sprayed into the air filter) when
starting the engine using a glow plug (applicable
models). These materials are extremely flammable
and explosive, and can melt parts or possibly
explode when used to help start the engine.
Cutting Safety
 The direct work area should not contain buried or
embedded electrical, gas, or water lines that could
be damaged and/or cause personal injury while
cutting.
 Turn off all electricity, gas, and water around the
direct work area prior to cutting.
 DO NOT expose yourself or anyone else to the
direct line of the blade when operating the saw.
 DO NOT allow any person, animal, and/or objects in
and around the work area while cutting.
Hydraulic Safety
 Turn off the engine prior to servicing hydraulic
components.
 Lower the saw completely prior to servicing to
decrease the hydraulic pressure in the lines.
 Always make sure any hydraulic components being
serviced are not supporting the weight of other saw
components. If a particular component is under
pressure when connection points are loosened, oil
may spray out forcefully.
 Always place a piece of cardboard or
paper up against hydraulic components,
or use a leak detection fluid to check for
hydraulic fluid leaks. Keep all body
parts away from leaks and/or areas that may eject
hydraulic fluid. Pressurized hydraulic fluid can
penetrate the skin, causing serious injuries. Seek
medical attention immediately!
Belt Safety
 Turn off the engine and let the belts cool down prior
to servicing them.
 Regularly inspect the belts for fraying, stress cracks,
and/or breakage and replace immediately when
damaged. Always check the belt alignment prior to
operating the saw.
 Use extreme caution when working with belts and
rotating machine parts to avoid entanglement.
 Over-tensioning belts may reduce the life of the
gearbox bearings. Under-tensioning belts may
cause slippage, shorter belt life, and/or poor saw
performance.
 Squealing belts indicate looseness.
 DO NOT use old and new belts together on the
same sheave.
Transporting Safety
 Remove the blade prior to transporting the saw.
 Make sure the truck/trailer is in good, working
condition and sufficient to transport the load. DO
NOT tow the saw behind a vehicle.
 Close the fuel shutoff valve (applicable models)
when transporting.
 Drain the fuel tank when transporting long distances.
 Use heavy-duty ramps that will support the weight of
the saw and yourself when loading or unloading.
 Raise the saw to avoid damaging components while
moving up and down ramps.