Dixon Valve CM400 crimper - Manual (Page 2)

Dixon Valve & Coupling Co.
800 High Street
Chestertown, MD 21620
800.355.1991
Fax: 800.283.4966
www.dixonvalve.com
Hose
Coupling
Safety
© 2005 DVCC Printed in the USA
Dixon
Holedall Crimp Fittings
and Ferrules
1½", 2", 3", and 4" crimp combination nipples
Cast stainless steel and carbon steel stems and ferrules
Uses notched ferrules so stems are reusable
• Use Dixon couplings,
retention devices and
accessory products
only
for their intended service.
• All recommendations of
the Hose Manufacturer,
and the Coupling
Manufacturer, must be
employed with regards to
Size, Temperature,
Application, Media, and
Pressure when selecting
the components for a
hose assembly.
• All finished hose
assemblies should be
tested in accordance
with the Rubber
Manufacturers
Association
recommendations.
• All hose assemblies
should be thoroughly
inspected prior to each
use to insure they are
undamaged, and
properly coupled.
• Use safety clips on
couplings, and King
Safety Cables on
assemblies where
required by the
manufacturer, as well as
State and Federal
regulations.
• Call Dixon (1-800-355-
1991) for advice on
couplings, retention
devices, and
accessories for your
application.
• Clamp end configuration
• 1", 1½", 2", 3", and 4"
• 316 stainless steel stems
• 304 stainless steel ferrules
Sanitary Fittings
• Holedall
1½", 2", 3", and 4"
Carbon steel and stainless steel
crimp combination nipples
• Notched cam and groove
1½", 2", 3", and 4"
Stainless steel
• Configurations available in Spring 2006
• Bevel Seat end
• I-line end
• Tube Weld end