Pach and Company AeGIS 9000 Series Manual - Manual (Page 35)

FUNCTION CODE LOCAL PROGRAMMING
• If the PBX is enabled, the system
will not dial a PBX extension.
43
OPEN DOOR 1 AND DOOR 2
NUMBER (REMOTE ACCESS
NUMBER) OR CCTV SWITCH
(Default setting is 9 to unlock
relay 1 (door 1) or 8 to unlock
relay 2 (door 2) or
CCTV is 6 to Open and 7 to close
the camera)
Step 4 Enter the PBX number to get the outside line (up to 3-digit), then press #, the
display shows
Step 5 Select another Function Code to program different field from the table or
press * to exit the programming mode.
Step 1 Log on to programming mode (see section 3.1). The display shows
Step 2 Enter Function Code 43 then press # and the display shows
Step 3 Enter (0-9) then press #,
Step 4 Enter (0-9) then press # the display shows
Pach and Company Chapter 3 Page 27
AeGIS 9000 Series PROGRAMMING
PBX Area No.
_ _ _
SELECT PROGRAM
ENTER: _ _ PRESS #
SELECT PROGRAM
ENTER: _ _ PRESS #
Open Door1No(0-9)
ENTER: _ PRESS #
If relay 2 (door 2) is set for Mode 1
(door control), the display shows
proceed to step 4
if the number is already used the
display shows
return to step 3
if relay 2 is set for Mode 4 (CCTV
Switch), the display shows
proceed to step 4
if the number is already used the
display shows
return to step 3
Open Door2No(0-9)
ENTER: _ PRESS # OpenCCTV No (0-9)
ENTER: _ PRESS #
This No is used
Please try again This No is used
Please try again
If relay 2 (door 2) is set for Mode 1
(door control), the display shows
proceed to step 5
if relay 2 is set for Mode 4 (CCTV
Switch), the display shows
Enter (0-9) then press # , the
display shows
proceed to step 5. If the number is
already used, the display shows
re-enter the number.
SELECT PROGRAM
ENTER: _ _ PRESS # CloseCCTV No (0-9)
ENTER: _ PRESS #
This No is used
Please try again
SELECT PROGRAM
ENTER: _ _ PRESS #