PASCO ME-8735 Large Rod Stand - Manual

Instruction Sheet
for the PASCO
Model ME-8735
Large Rod Stand
012-05338A
12/93
$1.00
© 1993 PASCO scientific
This instruction sheet written/edited by: Eric Ayars
clamp screws (2)
leveling feet (2)
When using the Large Rod Stand keep the following
in mind:
➀ The mass of the Large Rod Stand is approximately 9
lbs. (4 kg). If dropped, the Large Rod Stand may be
damaged, cause damage to other equipment or cause
injury. To prevent personal injury and damage, al-
ways carry the Large Rod Stand with a firm grip and
try to setup the Large Rod Stand away from the edge
of any table or work bench whenever possible.
➁ To prevent the Large Rod Stand from tipping or top-
pling over during experiments, be reasonable as you
setup experiments. Always be sure the Large Rod
Stand is able to rest firmly when any possible mo-
tion of your experiments occur.
Introduction
The PASCO Model ME-8735 Large Rod Stand can be
used whenever a sturdy base for your vertical support
rod is needed.
Rods with an outside diameter of 1/4" to 1/2" (6.5mm
to 13mm) may be placed in either the central mounting
hole and/or the alternate mounting hole at the peak of
the stand. They can be secured to the stand with either
of the two clamp screws provided.
The Large Rod Stand can be leveled by turning the
knobs on the leveling feet.