PASCO UI-5000 850 Universal Interface Instruction Manual User Manual
850 universal interface, Pasco
Advertising
Table of contents
Document Outline
- Table of Contents
- 850 Universal Interface
- Equipment
- Introduction
- Interface
- Software
- Multiple Interfaces
- Computer Requirements for the 850 Universal Interface
- General Operation Requirements and Setup
- A. Operation Requirements and Precautions
- B. Connecting the 850 Universal Interface to Your Computer
- C. Starting the 850 Universal Interface
- D. Plugging a Sensor into the 850 Universal Interface
- Extender Cables
- Using the Interface with PASCO Capstone Software
- A. Setup
- B. Displays
- Graph Display
- Axes Measurement Selection Menus
- Graph Appearance Features.
- C. Collect Data - the Controls Palette
- D. More Information About PASCO Capstone
- Using the 850 Interface as a Signal Generator
- Output Ports - Front Panel
- To use 850 Output 1 as a Signal Generator for a Circuit (or Other Device):
- A. Connect the Interface
- B. Signal Generator Controls: 850 Output 1
- Adjusting the Signal Generator Controls
- Method #1
- Method #2
- Method #3
- Sweep Type and Frequency
- C. Signal Generator Controls: 850 Outputs 2 and 3
- Cables
- D. Set Up an Example Output Signal
- E. View the Output Signal in a Capstone Display
- Hints for Help
- Troubleshooting
- What is the 850 Universal Interface?
- How do I know if my computer has a USB port?
- My computer has two USB ports. Can I use more than one PASCO USB interface at the same time?
- Is the 850 Universal Interface compatible with PASCO’s complete line of sensors?
- Does the 850 Universal Interface work with other software?
- Does PASCO Capstone software work with other interfaces?
- If I have the 850 Universal Interface and some PASPORT interfaces connected at the same time, which interface would be recognized first and have priority?