American Standard SELECTRONIC 6065.565 - Manual (Page 7)

M968699 Rev. 1.15
Fig. 11b
3
HOW TO CHANGE THE BATTERY;
(purchased before June 2013) Fig.12
6
3
3
9
1. Remove COVER (1) from SUPPLY STOP (2) if
installed. Fig. 10.
2. Turn water supply off. Fig. 10.
3. Loosen SPUD COUPLING NUT (3). Unthread
COUPLING NUT (4) and VACUUM BREAKER
COUPLING NUT (5). Remove FLUSH VALVE (6).
Fig. 10.
4. Clean all threaded connections before installing the
new flush valve. Fig. 10a.
5. Refer to Sections 5,6 and 7 to complete the retrofit
installation. Fig. 10b.
Note: In most Retrofits the wall escutcheon, supply stop,
cover tube and vacuum breaker do not have to be replaced.
If these items do need replacement they must be purchased
separately or order the complete flush valve assembly from
American Standard.
HOW TO RETROFIT OUR VALVE;
Fig. 10 8
(Replaces Industry Standard Manual and
Electronic Valves)
CLEAN
CONNECTIONS
1. Loosen SET SCREW (1) with 2.5mm Hex Wrench (2)
in back of top half of FLUSH VALVE CAP (3). Fig. 11a.
2. Rotate CAP (3) to the right and pull off. Fig. 11b.
3. Turn CAP (3) over and disconnect the SENSOR (4)
from the BATTERY CABLE (5). Remove the BATTERY
HOLDER (6) with BATTERY (7). Fig. 11c.
4. Remove old BATTERY (7). Install the new BATTERY
(8) making sure the shape of the BATTERY (8) follows
the shape of the BATTERY HOLDER (6). Fig. 11d.
5. Insert the BATTERY HOLDER (6) with BATTERY (8)
into FLUSH VALVE CAP (3). Make sure the flat side of
the BATTERY HOLDER (6) is facing towards the back
of the FLUSH VALVE CAP (3). Reverse the above
steps to assemble flush valve. Fig. 11d.
HOW TO CHANGE THE BATTERY;
(purchased after May 2013) Fig. 11
1
10
10
7a
9
6
6a
Fig. 11a
Fig. 11
Fig. 12
REMOVE OLD
BATTERY
REMOVE OLD
BATTERY
INSTALL NEW
BATTERY
INSTALL NEW
BATTERY
2
4
6
6
5 CR
-P2
CR -P2
8
7
Fig. 11c
Fig. 12a Fig. 12b
9a
1. Remove CAP (3). Refer to Step 9 above. Fig. 11a.
2. Turn CAP (3) over and remove the two SCREWS
(9). Remove the BATTERY COVER (10) to expose the
battery (6a). Fig. 12a.
3. Remove old BATTERY (6a). Install the new
BATTERY (7a) making sure the + & - are facing up
towards the open end of the cover. Fig. 12b.
4. Replace the BATTERY COVER (10) reverse the
above steps to assemble flush valve.
Fig. 11d
2
Fig. 10 Fig. 10a Fig. 10b
1
4
5
3
6