ATON AH66T - Manual (Page 12)

A T O N AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 11
ATON pre-wiring recommendations for connections to the AH66T
Item Description
OLED2 Touchpads Category 5 cable
IR Receivers Category 5cable
Volume Controls Category 5cable for control wiring
16-18 AWG 2 or 4 conductor wire for speaker wiring
Use stranded, twisted pair speaker wire between amplifiers and volume controls,
and between volume controls and speakers.
Speakers 16-18 AWG speaker wire
Use stranded, 2 or 4 conductor speaker wire between amplifiers and speakers.
Remotely Located Sources Category 5 cable
RG6 or RG59 coax (if necessary)
ELAN C2 Communications
Controller Category 5 cable When using an ELAN C2 Communications Controller, run Cat-5
for telephones and door stations. See the C2 Installation Manual for details.
Serial Devices Category 5 or Serial Cable
Run Cat-5 or serial cables between RS-232 controllers and the AH66T.
Sense Inputs Category 5 (3 conductors used)
Use Cat-5 to extend sensor leads, if necessary.
System Audio RCA Interconnect Cables