ATON AH66T - Manual (Page 14)

A T O N AH66T INSTALLATION MANUAL
© ATON 2010 | All rights reserved. Page 13
Stereo Zones
To create an independent stereo zone, simply connect the AH66T’s Speaker Outputs to a
pair of speakers. Make sure to take into account the amplifier’s 8 Ohm minimum
impedance when choosing and configuring speakers. Volume is controlled at preamp level
using IR or RS-232 commands. Any speakers connected to these channels ramp volume
up/down together. Use an OLED2 touchpad or hand-held remote control to control
functions (including volume) in zones with this configuration.
Figure 2-1 shows a typical stereo zone example.