Teledyne GFC-7000E - Trace CO2 Analyzer User Manual
Page 98
Model GFC7000E Instruction Manual
Operating Instructions
04584 Rev A1
87
Press the following keys to select a communication mode for a one of the COMM Ports, such as the
following example where HESSEN PROTOCOL mode is enabled:
Continue pressing next until …
SETUP X.X
PRIMARY SETUP MENU
CFG DAS
RNGE
PASS CLK
MORE
EXIT
SETUP X.X
SECONDARY SETUP MENU
COMM
VARS DIAG ALRM
EXIT
SAMPLE* RANGE = 500.000 PPM CO2 =X.XXX
< TST TST > CAL
SETUP
SETUP X.X
COMMUNICATIONS MENU
ID
COM1
COM2
EXIT
SETUP X.X
COM1 MODE:0
SET>
EDIT
EXIT
SETUP X.X
COM1 QUIET MODE: OFF
NEXT
OFF
ENTR EXIT
SETUP X.X
COM1 HESSEN PROTOCOL : ON
PREV NEXT
ON
ENTR EXIT
SETUP X.X
COM1 HESSEN PROTOCOL : OFF
PREV NEXT OFF
ENTR EXIT
Continue pressing the NEXT and PREV keys to select any other
modes you which to enable or disable
SAMPLE
ENTER SETUP PASS : 818
8 1 8
ENTR
EXIT
Use PREV and NEXT
keys to move between
available modes.
A mode is enabled by
toggling the ON/OFF
key.
Select which COM
port to configure
EXIT returns
to the
previous
menu
ENTR key accepts the
new settings
EXIT key ignores the
new settings
The sum of the mode
IDs of the selected
modes is displayed
here