Victory UR-48-SBS - Manual (Page 7)

C. Locating your New Storage Freezer, Refrigerator (continued)
3. Ventilation - The air cooled, self-contained refrigerator or freezer demands a sufficient amount of
cool clean air. Avoid placing the refrigerator or freezer near heat generating equipment, such as
ovens, ranges, heaters, fryers, steam kettles, etc., and out of direct sunlight. Avoid locating the self-
contained refrigerator or freezer in an unheated room or where the room temperature drops below
55
°F.
4. Ambient Temperature - Salad/Sandwich refrigerator and pizza tables are approved for operation
under NSF-7 (+41
°F) in a maximum ambient of +86°F.
D. Installing Legs or Casters
Correct installation is very important to proper operation. This model must be - level when it is installed.
If cabinet is not level….
1. Doors may not seal properly.
2. Defrost water may overflow coil drain pan.
3. An excessive amount of ice may accumulate in coil drain pan of freezer models.
This model is supplied with adjustable type legs for leveling purposes. Legs are packaged and taped with
the cabinet for shipment. The legs must be secured to the leg braces on the underside of the cabinet. The
legs should be installed immediately after shipping skid has been removed.
Tip the model in one direction, block it from falling by using several pieces of 2 x 4 lumber or other
suitable material. Install legs securely while the model is in that position. Repeat this procedure to install
the remaining two legs.
Note: The above information pertains to “Casters” also.
E. Removal of Drawer Assembly
1. Remove drawers from cabinet by pulling the drawer forward and lifting rollers out of notched front
end of slide.
2. Push slide back so that slide support rollers clear retaining strap. Lift out left hand and right hand
slides.
3. Lift front end of slide support channels to disengage rivets from keyhole slots in front of mounting
bracket. Pull forward slightly to disengage rear rivets from keyholes in rear bracket. Lift out side
support channel.
4. Remove screws holding front brackets on both sides of tank.
5. Rear brackets may be taken out if necessary by removing thumb screws holding them to the sides of
the tank.
4
Section 2-Installation Section 2-Installation