Emergi-Lite Survive-All SVX-HZ Series - Manual (Page 4)

SVXHZ Series – Exit Sign
4/4
Emergi-Lite
Tel: (888) 552-6467 ext. 547 or 255 Fax: (888) 867-1565 www.emergi-lite.com 06/07 750.1300 Rev. A
Double Face Installation
Installation Instructions
1. Turn off unswitched AC power.
2. Remove backplate by unscrewing the four tamper-proof screws hold-
ing the backplate to the frame (see fig. 8)
3. Install the four backpanel retention screws (see fig. 9)
Note: The four screws may already be installed.
4. Install the diffuser panel by snapping the top edges under the two top
retention screws and then snapping the bottom edges under the two
bottom retention screws (see fig.10).
5. The EXIT panel installs in the same manner (if required, remove the
appropriate chevron).
6. Install the lens by using the 4 short and 2 long tamper-proof screws
(see fig.11).
The tamper-proof screws should be equally torqued to approxi-
mately 5 lbs-in (0.6 N-m).
7. Energize AC. Sign will illuminate.
Figure 8
Backplate
screws
tamper-proof
Figure 9
Backpanel retention screws
Figure 10
Snap panel under
these screws
Figure 11