FEC AFC1100 - Manual (Page 14)

)(& ,QF
7.3.3 Setup mode operation.
Depressing the [MODE] switch will bring up the
setup mode. A blinking digit will appear in the
[PARM] display specifying the cursor position.
Use the [ ↓↓↓↓ ] and [ ↑↑↑↑ ] keys to select the desired
parameter number.
Press the [SET] key to enter the Data Edit mode,
where you can change the values appearing in the
[DATA] display section or press [MODE] to select a
different [DATA] display function.
Use the arrow keys to change the data number.
(Data Number Correspondence Chart, section
7.3.6)
Pressing the [MODE] key Moves the cursor.
Pressing it four times causes the system to exit out
of the edit mode, returning to the parameter
number selection without saving any changes. Use
the [
↓↓↓↓ ] and [ ↑↑↑↑ ] keys to decrease or increase the
value number.
Pressing the [SET] key will enter the new values
shown in the DATA display. If the entered values
are inappropriate, "Err" will appear, and the new
data will be ignored. In this case return to the
parameter number selection (using the [MODE]
key) and retry.
FIG. 7-3-3 Setup mode operation
When the torque unit number or the tool type is changed, the [DATA] display will show
"CHNG," and the ANGL.SPNO display will show "NO." Use the vertical arrow keys to choose
YES or NO; YES means that the data will be entered if the confirmation SET key is pressed.
The [SET] and [MODE] switches will have no effect when "NO" appears. If no key is pushed
in five seconds, the new data will be ignored, and the system will exit the Data Edit mode
.
Warning:
When the torque unit (PARM 0, and D-NO 00) or the tool type (PARM 0, and D-No
20-28) is changed, the torque (D-No 00-18) and the speed (D-No 50-54) will be cleared.
Chapter 7: System Operations (Rev. 8/98)
Page 7-14
AXIS UNIT INDICATION
U.XX
PARAMETER NUMBER
SELECTION
DATA NUMBER SELECTION
(left digit)
DATA NUMBER SELECTION
(right digit)
DATA
MODE MODE MODE
DATA EDIT
MODE
MODE
MODE
SET
MODE
SET
SET
MODE
MODE
SET