FEC AFC1100 - Manual (Page 4)

)(& ,QF
2. Abnormal number "7" is shown
PARM
ABN
3. When the CAL switch is pressed, "E" is shown if the FULL-SCALE preset value is
missing or a wrong tool is connected.
PARM
ABN
Indicates the parameter number used for the previous fastening operation. Should an
abnormal condition occur the display will indicate the nature of the abnormality through a code
number (Refer to Chapter 9).
w[ANGL/SPNO] Angle data/Axis unit number indicator.
Display for the final angle value of the previous fastening operation. The angle value is
given in integers numbers. Directly after the power is turned on and while the RESET signal is
active the spindle number is displayed.
Chapter 7: System Operations (Rev. 8/98)
Page 7-4
ANGLE
SPNO
.
SPINDLE NUMBER
ANGLE
SPNO
ANGLE DISPLAY