FIREPOWER Firefinder XLS - Manual (Page 5)

s Industry, Inc.
Building Technologies Division
All cards plugged into the CC-5 / CC-2 card cage
communicate with other FireFinder-XLS modules via a
common data bus. Connectors are provided on the left and
right side of the CC-5 to connect a 60-pin cable for
communications with the FireFinder-XLS' operator interface,
power supplies and amplifiers modules.
Field wiring to devices and circuits terminates on the
Models CC-5 / CC-2 card cages. All cards designed for use
with the Models CC-5 / CC-2 route their field wiring
terminations to the ‘top’ of the Model CC-5 / CC-2 card
cages. These connections are all power limited. Internal
wiring connections distribute 24VDC to cards or high-level
audio signals (depending on application used) connect to
the ‘bottom’ of the Model CC-5 / CC-2 card cages. These
connections are all non-power limited.
All wiring connections to the Model CC-5 / CC-2 card cages
are to removable terminal blocks. Terminal blocks are rated
for use with wire sized 12AWG to 24AWG. Each connector
is numbered to make wiring terminations to the correct
position on the terminal block simple in order to reduce
potential wiring errors.
SCM-8 Switch Control Module
SCM-8 Switch Control Module
The Switch Control Module (Model SCM-8) is a FireFinder
XLS-option module that provides manual control to the
Emergency Voice Evacuation System (EVAC) or manual
fire-system control. Each Model SCM-8 module provides
eight (8) momentary push-button switches and 16
light-emitting diodes (LEDs) to indicate their status.
Each switch is assigned two (2) LEDs, as well as a label
to indicate the switch's programmed usage. The label
slides behind a clear protective membrane. One of the
LEDs assigned to each switch is a dual-colored LED,
which is used to indicate what type of signal is active.
Each Model SCM-8 switch is fully programmable, and may
be used to control speaker circuits and a wide range of
general-system functions such as: All Call, All Evac,
Warden's Page, Speaker, etc. Any number of circuits may
be grouped and controlled by a single switch. Switch
usages and zone groupings are assigned using the Zeus
system software-programming software. Model SCM-8
modules are mounted on a hinged panel, as a part of the
FireFinder XLS Command Console enclosure.
LCM-8 LED Control Module
LCM-8 LED Control Module
The LED Control Module (Model LCM-8) is a FireFinder
XLS-option module that provides LED annunciation for
FireFinder XLS system activity. Each LCM-8 module
contains eight (8) groups of two (2) LEDs – each of which
can be assigned to desired outputs using the Zeus
system software-programming tool.
Eight (8) LEDs are dual-color capable (RED or GREEN,
flashing or steady). The remaining LEDs are AMBER
flashing or steady. A space is provided for labeling of LED
functions. The label slides behind a clear, protective
membrane. Model LCM-8 dimensions are identical to Model
SCM-8, and Model LCM-8 is mounted on the same hinged
panel, as a part of the FireFinder XLS Command Console
enclosure.
FCM-6 Fan, Motor, Dampers
Control
Module
FCM-6 Fan, Motor, Dampers Control Module
The Fan, Motor, Dampers Control Module (Model FCM-6) is a
FireFinder XLS command-console option module that
provides manual control of building HVAC system fans,
motors, and dampers. Each Model FCM-6 module provides
six (6) sets of three (3) push-button switches for manual-
system control. Each switch has three (3), associated
LEDs to indicate Fan / Damper / Motor status: OFF (Red LED),
ON (Green LED), TROUBLE (Yellow LED).