FIREPOWER Firefinder XLS - Manual (Page 8)

s Industry, Inc.
Building Technologies Division
CAB2 Two Row Enclosure
CAB2 Two Row Enclosure
The Two Row Enclosure (Model CAB2) is the mid-sized
FireFinder XLS enclosure capable of housing up to two (2)
Model CAB-MP cabinet mounting plates. The inner door
has two (2) rows of four (4) mounting slots. The outer
door has space for mounting two (2) outer door plates
(Models OD-LP, OD-BP or OD-GP). The outer door can be
configured to open from either side. Model CAB2 consists
of the Model CAB2-BB back box, the Model CAB2-BD black
inner and outer door package, and one (1) Model OD-LP lens
plate. The outer door has a single lock and key set installed.
A red version (Model CAB2R) is also available. Approximate
size is 45” (114.3cm.) high, 26” (66cm.) wide, and 8”
(20.3cm.) deep.
CAB3 Three Row Enclosure
CAB3 Three Row Enclosure
Model CAB3, the single largest FireFinder XLS enclosure
available, can house a maximum three (3) Model CAB-MP
cabinet mounting plates in the enclosure, and three (3)
rows of inner-door mounting slots. The outer door can
be configured to open from either side. Model CAB3
consists of the Model CAB3-BB back box, the Model CAB3-
BD black inner and outer door package, and one (1) Model
OD-LP lens plate. The outer door has two (2) locks and key
sets installed. A red version (Model CAB3R) is also available.
Approximate size is 63" (160cm.) high, 26" (160cm.)
wide, and 8" (20.3cm.) deep.
Enclosure Trim Kits
Trim kits are available for all system enclosures for semi-
flush mounting applications. Model CAB1-TK (for black
enclosures) and the Model CAB1R-TK (for red enclosures)
fit inside the Models CAB1 and CAB1-R enclosures.
Similarly, Models CAB2-TK and CAB-2R-TK fit inside the
Model CAB-2 enclosure, while Models CAB3-TK and CAB3R-
TK fit the Model CAB-3 enclosure.
Remote Transponders
The FireFinder XLS system can use remote transponders
for mounting additional modules such as amplifiers
without requiring Model PMI or any control switches.
Special doors are available for systems using Model CAB-2
or Model CAB-3 remote transponders. These doors
(Models CAB2-XBD and CAB3-XBD) omit the unused
inner door, and come complete with ventilation louvers
built into the door.
Model CAB2-XBD fits into Model CAB2-BB, and Model
CAB3-XBD fits into Model CAB3-BB. Model CAB2-XBD and
CAB3-XBD are supplied in black. Red versions (Models
CAB2-XRD and CAB3-XRD) are also available. Complete box
and door kits are available, Models CAB2-X and CAB3-X.
CAB-MP Cabinet Mounting Plate
CAB-MP Cabinet Mounting Plate
The Model CAB-MP cabinet mounting plate provides
mounting for a single row of modules in a FireFinder XLS
cabinet. Four module spaces are available on the CAB-MP.
The CAB-MP is used to mount the CC-5 card cage, the
CC-2 card cage, the PSC-1 2 power supply, the PSX-12
power-supply extender, and the ZAM-80/1 80-zone
amplifiers.
ID-MP Inner Door Mounting Plate