Acer Altos R710 - Manual (Page 58)

4 Configuring the system 46
7 Insert one end of the 26-pin floppy drive data cable end into the
connector.
8 Push down on the connector cover to lock the cable into place.
9 Slide the floppy drive assembly into the chassis until it clicks into
place. See letter “A” in the figure below.
10 Open the connector on the backplane by pulling out on the
connector cover. See letter “B” in the figure below.
11 Insert the loose end of the floppy cable into the backplane
connector. See letter “C” in the figure.
TP01144
A
B
C