Removing a floppy drive from the slim line drive – Acer Altos R710 User Manual
Page 59
![background image](/manuals/34613/59/background.png)
47
12 Push in on the connector cover to lock the cable into place. See
letter “D” in the figure.
13 Install the chassis cover.
14 Install the front bezel.
Removing a Floppy Drive from the Slim Line Drive
bay with Altos R710
1
Power down the server system and unplug all peripheral devices
and the AC power cable.
2
Remove the chassis cover.
3
Remove the front bezel.
4
Open the connector on the rear of the floppy drive by pulling up
on the connector.
5
Remove the data cable from the rear of the floppy.
6
Push in on the blue lever at the rear of the drive carrier Remove
the drive carrier at the left side of the chassis to release the drive
carrier.
7
Slide the drive carrier out through the front of the chassis.
8
Press downward on the side of the drive tray and release the drive.
9
Remove the small screw that attaches the interposer board to the
drive.
10 Store the screw and floppy carrier for future use. Suggestion: tape
the screw and backplate to the top surface of the drive bracket.
11 Install the slim line filler panel into slim-line bay.
12 If installing a new floppy drive start from step “Install a Slimline
Floppy Drive into Altos R710”
13 Install the chassis cover.
14 Install the front bezel.