Acer Altos R710 - Manual (Page 71)

59
Install a Slimline Optical drive into Altos R710
NOTE:The carrier for the slimline Optical drive was pre-installed in
the slimline drive bay of your Altos R710 Server You will need to
remove it from the chassis before beginning.
1 Power down the server system and unplug all peripheral devices
and the AC power cable.
2 Remove the chassis cover.
3 Remove the front bezel.
4 Align the two holes at left edge of DVD-ROM /CD-ROM drive with
the cutouts in drive carrier. See letter “A” in the figure below.
5 Lower the right side of the DVD-ROM / CD-ROM drive into the
carrier until it clicks into place. See letter “B” in the figure below.
6 Use the two screws indicated in the figure to attach the interpose
board to the DVD-ROM / CD-ROM drive. See letters “C” and “D” in
the figure.
7 Attach the 44-pin CD-ROM drive cable to the exposed side / back
of the interposer board. See letter “E” in the figure.
8 Insert the DVD-ROM / CD-ROM drive into the chassis. See letter
“A” in the figure below.
A
B
C
D
E
D