Darex XPS-16 SCHEMATICS & WORK INSTRUCTIONS - Manual (Page 25)

User Manual Page 25
Removing and Replacing Switches
Removing and Replacing The E-Stop, Cycle Start
and Feed Hold Switches
To remove the power switches, remove the
screws from the door support casting and top
cover.
Remove the support door casting and tilt it up.
.
E-Stop
1. Using a pair of needle nose pliers, hold the
switch block down with your thumb. Grab the
connectors and gently pull up while using a
rocking motion and remove the 2 wires.
2. Connected to the switch is the switch block.
Note the small key in the center left and to the
right is a release clip. With a small blade screw
driver reach down on the side of the clip and
press inward while pulling up. The block will
slide off.