Darex XPS-16 SCHEMATICS & WORK INSTRUCTIONS - Manual (Page 35)

User Manual Page 35
Removing and Replacing the Spindle Arbor Cartridge Assembly
Removing and Replacing the Spindle Arbor Car-
tridge Assembly.
1. Refer to Grind Motor Belt Replacement instruc-
tions and remove belt. See Section 24 Sche-
matics and Work Instructions page 29.
2. Remove the 4, 3mm screws on the wheel
cover. Remove, leaving hose attached to
cover.
3. Slide the arbor lock pin through the hole in the
wheel guard casting and rotate wheel until it
engages.
4. With a ½” socket, remove the wheel retainer
nut and remove the wheel.
5. Remove the 4, 4mm screws holding the wheel
casting in place.
The casting is pinned to the cartridge block.
With gentle pressure pull the casting from the
block but do not disconnect any wires. It may
be necessary to tap with a soft mallet. Care-
fully place the casting out of the way.
6. Loosen the 3mm set screw from the drive pul-
ley, but do not remove.