Darex XPS-16 SCHEMATICS & WORK INSTRUCTIONS - Manual (Page 8)

User Manual Page 8
Removing and Replacing the Chuck Belt Idler Assembly
Refer to the Chuck Spindle Drive Belt Replacement
instructions for cover and chuck removal, belt ad-
justment and reassembly after replacement of belt
idler. See Section 24 Schematics and Work In-
structions page 3.
1. Remove the 4mm locking screw and lift the
idler assembly out of the housing.
To install the idler, position over screw hole
outside of belt and thread screw into idler just
until snug. Adjust belt per the
Chuck Spindle
Drive Belt Replacement instructions. See Sec-
tion 24 Schematics and Work Instructions
page 3.
Idler assembly
4MM locking screw