Direct Lift PP8 Plus Long User Manual
Page 12
12
4.
Do not let a cord hang over the edge of the table, bench, or counter or come in contact with hot mani
folds or moving fan blades.
5.
If an extension cord is necessary, a cord with a current rating equal to or more than that of the equip
ment should be used. Cords rated for less current than the equipment may overheat.
6.
Always unplug equipment from electrical outlet when not in use. Never use the cord to pull the plug from
the outlet. Grasp plug and pull to disconnect.
7.
Let equipment cool completely before putting away. Loop cord loosely around equipment when storing.
8.
To reduce the risk of fire, do not operate equipment in the vicinity of open containers of flammable liquids
(gasoline).
9.
Adequate ventilation should be provided when working on operating internal combustion engines.
10.
Keep hair, loose clothing, fingers, and all parts of body away from moving parts.
11.
To reduce the risk of electric shock, do not use on wet surfaces or expose to rain.
12.
Use only as described in this manual. Use only manufacturer’s recommended attachments.
13.
ALWAYS WEAR SAFETY GLASSES. Everyday eyeglasses only have impact resistant lenses, they are not
safety glasses.
SAVE THESE INSTRUCTIONS
SAFETY PROCEDURES
•
Never allow unauthorized persons to operate lift. Thoroughly train new employees in the use and care of
lift.
•
Caution - the power unit operates at high pressure.
•
Remove passengers before raising vehicle.
•
Prohibit unauthorized persons from being in shop area while lift is in use.
•
Total lift capacity is 8,000-lbs. Do not exceed this capacity.
•
Prior to lifting vehicle, walk around the lift and check for any objects that might interfere with the opera
tion of lift and safety latches; tools, air hoses, shop equipment.
•
When approaching the lift with a vehicle, make sure to center the vehicle between the columns. Slowly
drive the vehicle up with some one outside the vehicle guiding the driver.
•
Prior to lowering vehicle, walk around the lift and check for any objects that might interfere with the
operation of lift and safety latches; tools, air hoses, shop equipment.
•
Slowly drive the vehicle on and off of the lift. Have some one outside the vehicle guide the driver.
CAUTION!
LUBRICATE ALL CABLE SHEAVES, BEARINGS, AND SHAFTS WITH GREASE PRIOR TO OPERATING THE LIFT.
LUBRICATE ALL ON AN ANNUAL BASIS.
Motors and all electrical components are not sealed against the weather and moisture. Install this lift in a pro-
tected indoor location. Failure by the owner to provide the recommended shelter could result in unsatisfactory
lift performance, property damage, or personal injury.
OPERATION INSTRUCTIONS
NOTE: ALWAYS CHOCK WHEELS AND SET PARKING BRAKE BEFORE LIFTING VEHICLE!
Only authorized personnel are to operate lift. Read Operating and safety procedures Manual completely before
operating lift.