Fairbanks 4100 SERIES Pallet Weigh Plus - Manual (Page 10)

Section 2: General Policies
10/13 10 51287 Rev. 2
2.1.3. Safety
1. NEVER lift a heavy load with just the points of the
forks. This could damage the electronic weighing
elements permanently.
2. NEVER weigh without a pallet. This could affect the
accuracy of the weighing result.
3. The unit may be loaded with weights up to 5000 lb.
However, we advise you not to move any weights
above 1650 lb. (750 kg) with the unit. Fairbanks
Scales is not responsible for injury that may result
when moving heavy loads.
4. Use caution in the vicinity of moving parts - these parts can cut and/or crush
hands, arms, feet and legs.
5. Always center the load you are lifting on both of the forks.
6. Do not operate the weighing system on ramps, inclines, or declines, without the
addition of our optional parking brake.
7. Do not operate the weighing system while others are on or near the unit.
No riding!
8. All modifications must be approved in writing from the supplier, prior to any work
being completed.
9. It is the sole responsibility of the purchaser to train their own employees in the
proper use and maintenance of this equipment.
10. Do not operate this unit unless you have been fully trained of its capabilities.
11. Do not use the weighing system in potentially explosive areas.
12. Do not carry passengers with the truck.
13. Do not weld or make changes to the weighing system without consulting the
supplier.
14. Do not lift unstable loads.
15. Check the accuracy of the scale on a regular basis to prevent faulty readings.
16. Only trained and authorized personnel are allowed to operate the truck.
17. Always follow the operating, maintenance and repair instructions of this truck and
ask the supplier when in doubt.