Fairbanks 4100 SERIES Pallet Weigh Plus - Manual (Page 16)

Section 4: Operation
10/13 16 51287 Rev. 2
Indication Function
C2 ▼ Displayed weight is in range 2.
C3 ▼ Displayed weight is in range 3.
SP1 ▼ Feature not available.
SP2 ▼ Feature not available.
4.4. OPERATING THE SCALE
4.4.1. Power-Up the Scale
1. Press the key for two (2) seconds.
2. Allow 3 to 5 minutes until the electronics and load cells have reached
operational temperature. Inaccurate weights of up to 0.3% may occur if this
initial warm-up time is not observed.
4.4.2. Zeroing the Scale
1. If the scale does not indicate a zero, press the key to zero the scale.
2. The scale will indicate zero and is ready to perform weighments.
3. Before each weighment it is necessary to check whether the system is
unloaded and at a zero condition. The indicator is equipped with an automatic
zero correction. This means that small deviations of the zero point will be
corrected automatically. If the indicator does not determine the zero point
automatically, it must be performed manually using the key.
4.4.3. Gross Weight
1. After lifting a load, the display indicates the gross weight of the applied load.