Setup instructions – General Tools and Instruments DCS280 User Manual

Page 6

Advertising
background image

Fig. 2. The controls, indicators and connectors

of the DCS280

A.

Thread protector

B.

Camera head and LED lights

C.

9mm flexible-obedient probe

D.

LCD

E.

Battery compartment (on bottom of grip)

F.

button. Increases brightness of LED lights

G.

button. Inverts video 180°

H.

button. Decreases brightness of LED lights

I.

button. Enlarges video frame up to 2X. Each press of button increases

zoom level by 10 or 20%, relative to real size

J.

button. Powers unit on and off

K.

VIDEO OUT jack (behind LCD)

SETUP INSTRUCTIONS

INSTALL BATTERIES

The DCS280’s battery compartment is accessible
from the bottom of the grip (Fig. 2, Callout E).

To install batteries,

1. Use a Phillips-head screwdriver to loosen the single

screw securing the battery compartment cover.
Remove the cover and set it aside.

2. Extract the battery magazine from the grip by pulling

on the tab at its end (see top figure).

3. Load four “AA” batteries into the magazine, using

the polarity markings within it as a guide (see bottom
figure).

6

A

B

C

D

E

F
G

I

H

K

J

Advertising