KISAE HB 800 Home Backup - Manual (Page 12)

Page 12
Understanding the Error Code
Error
Code
Condition Corrective Action
E01
System senses battery voltage is low
and has shutdown. Recharge battery immediately and restart
unit.
E02
System senses battery voltage is high
and has shutdown. Check battery voltage or if any external high
voltage DC source is connected to DC Input
Port.
E03
System AC output is overloaded or
short circuited and has shutdown. Check load connected to AC output. Reduce
load and restart the unit.
E04
System senses high internal
temperature and has shutdown Turn unit off. Wait for 15 minutes before
restarting. Check if any object is blocking the
ventilation of unit.
E05
System warns battery voltage is low
and will shut down shortly Recharge battery as soon as possible or
system will shut down shortly.
E06
System warns AC load connected is
close to overload shutdown limit. Check load connected to AC output. Reduce
load.
E07
System warns of high internal
temperature and will shut down shortly. Reduce load. Check if any object is blocking
the ventilation of unit.
E08 -
09
Not used
E10
Internal battery is overcharged Check battery voltage or if any external high
voltage is connected to DC Input Port.
Solid red
“E01-E10”
Error on unit is detected. AC output is
disconnected. See Trouble shooting section.
Full
Automatic
Silent
In1, Al0
Same as “Full Automatic” mode but with audio alarm mute if error occurs. The
unit fault protection features remain active.
Backup
Disable
In0,Al1
Solid
green “Ful” AC output is supplied by utility power. Internal
battery is fully charged.
Flashing
green Battery
capacity in % AC output is supplied by utility power. Charging
of internal battery by 2A charger is in progress.
Backup
Disable
with Alarm
Disable
In0,Al0
Same as “Backup Disabled” mode but with audio alarm mute. The unit fault
protection features remain active.