Ransburg Serial Node Adapter LECU4002_78553 - Manual (Page 12)

Position 8:
This position enables a Bus Agreement Override
mode that allows the Serial Node Adapter/Serial
Node Adapter + to communicate between the
internal bus and the PLC when the two configura-
tions do not agree. In this mode the Serial Node
Adapter/Serial Node Adapter + will use the bus
configuration specified in the BTW configuration
word.
>
This mode should only be used for
troubleshooting. It is possible for data to
be communicated to the wrong module.
For this reason, bit 14 is set in the BTR
words 0, 1, and 2, indicating this
mode has been entered. The "CPU" in-
dicator on the Serial Node Adapter/Serial
Node Adapter + will flash also.
NOTE
1/4
1/2
3/4
Full
# SerDG
Modules
0 - 2
3 - 6
7 - 10
11 - 12
Rack Size
Figure 1: Position 6 & 7 Rack Size Settings
Figure 1: AdaptaFlow System Rack
Serial Node Adapter/Serial Node Adapter + - Introduction
Ransburg
8 LN-9238-02.3