Sonnet Technologies Crescendo_PCI Processor Upgrade Card - Manual (Page 27)

En
1-4
Figure 1; Figura 1
2. Insert the Crescendo/Encore Install diskette
into the floppy disk drive. Double click the
Crescendo/Encore Install icon. By default, with
“Easy Install” selected from the pop-up menu,
the required software will be installed into the
active System Folder on the boot drive. If this is
ok, click the Install button; otherwise, select
“Custom Install” from the pop-up menu for
more options or select another drive to install
the software. The installer will install the
appropriate software into the System Folder of
your computer. If the installation was success-
ful, a dialog box will appear. Click Quit to leave
the installer and shut down your computer.
Shut Down and Open Computer
1. Shut down your Power Macintosh. If the com-
puter has been on for any length of time, wait
a few minutes for it to cool before beginning
the installation.
2. Disconnect the power and peripheral cables
from the back of the computer and move it to
an area where you can freely work.
3. With the front of the computer facing you,
remove the case cover from your Power
Macintosh. Locate the two switches on the
underside of the front cover, depress them, and
slide the cover forward and off the computer
(Figure 1).
case cover
PCI TriManual-Chapters 1-13 3/30/01 5:55 PM Page 9