Animation ‘virtual’ audio trigger input setup, Inputs, Controlled from the show control sys – Gilderfluke&Co Sd-50 Audio & Show Controllers User Manual
Page 97: Animation, Virtual’ audio trigger input, Animation input setup, Animation ‘virtual’ audio trigger input, Animation ‘virtual’ audio, Trigger input, Animation ‘virtual’ audio trigger in
Animation ʻVirtualʼ Audio Trigger Input Setup
(Sd-50/8, and Sd-50/40)
This is NOT the port which triggers animation. This is the port that is used to trigger audio func-
tions from the animation data. Animation is normally triggered via the ʻ
ʼ port, which is set up when
AutoDownloading the shows from PC•MACs, or the
input, which is set up using the ʻMp3
Config.exeʼ programʼs ʻ
ʼ tab.
The Sd-50/8 and Sd-50/40 have eight ‘virtual’ Show Control outputs which can be used to control the .Mp3/.wav
player. In most cases when configuring a Sd-50/8 and Sd-50/40, you will use these ‘virtual’ show control outputs to control
the .Mp3/.wav player. The ‘
’ inputs will remain unused.
You can set any of the eight inputs as unused, an independent control, or part of a binary address. To set all the inputs
to any of these modes, just use the ‘All Unused’, ‘All Independent’ or ‘All Binary’ buttons. To set the inputs independently,
‘right’+click on the input you want to configure:
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Sd-50/xx Manual / October 29, 2012 2:29 PM / page 97 of 120