Gilderfluke&Co C-50 Trans User Manual
Page 2
2) Install the four 4–40 x ¼” tall male/female spacers into the four mounting holes in the
top of the Sd-50/40. To make them the required 5/16” tall, install two 1/32” thick washers
under each standoff before you screw it down.
3) Plug the C-50Trans into the Sd-50/40. It has a polarizing ‘bump’ on one side, so it will
only go in the correct way.
4) Screw the C-50Trans down using the four 4–40 x 3/16” screws.
5) The ten position ribbon cable plugs into the ‘¼ J6’ connector on the end of the Sd-50/
40.
You can now terminate discrete wires into the C-50Trans. If you are attaching ServoMotors, just
switch the ‘¼ J6’ Internal/External Power to the ‘External’ power position. Attach your ServoMotors’
five vdc supply to screw terminals #1 (ground) and #10 (+5 vdc) of the ‘¼ J6’ screw terminal block.
Plug the servos into the headers and configure the appropriate outputs for ServoMotor PWM control.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840–9484 • 800/776–5972 • fax 818/840–9485
East Coast/Florida Office • 7041 Grand National Drive • Suite 128d • Orlando, Fl. 32819 • 407/354–5954 • fax 407/354–5955
C-50Trans Manual / June 12, 2007 10:28 AM / page 2 of 2