IAI America FS - Manual (Page 32)

26
3. Connection to the Controller
For the controller, only the dedicated controller manufactured by our company can be used.
Using other controllers may cause a problem such as burning the product, ignition or generating heat.
Use the dedicated cable enclosed in the package when connecting the actuator and the controller.
In this section, describes how to lay out the wirings for the single axis use.
In the single axis use, unless otherwise specified, the actuator will be delivered with a single axis
dedicated cable with 3m or 5m of its length enclosed in. Plug in the connector on the cable end directly
to the controller.
x Although we use cable that is resistant to bending fatigue, it is not robot cable.
Please avoid housing the cable in a wire duct with a small bending radius (we recommend R90 or
larger).
x In an application where the cable cannot be anchored, try to place the cable where it will sag only
under its own weight or use self-standing cable hose as large radius wire duct to limit the load on
the cable.
x Do not cut the cable to lengthen, shorten, or reconnect it.
If you wish to alter the cable, please consult with IAI before doing so.