IAI America RS - Manual (Page 29)

2. Installation
23
[2] Installation of the Main Unit
Have the unit attached following the steps below;
1) Unscrew the flat-head screws on the sides of the unit cover and remove the cover.
2) There are 9mm through holes at 4 points on the main unit. Affix the unit with M8 screws.
3) Put the cover back on the unit and affix with the flat-head screws.
Mounting screw
Mounting screw
Cover
Flat-head screw
Flat-head screw
Flat-head screw
Flat-head screw
Tightening screws
x Use hexagonal socket head bolts for the male threads for installing the base.
x Use of high-tension bolts meeting at least ISO-10.9 is recommended.
x Use appropriate screws suitable for the attachment holes and attachment grooves.
x Do not attempt to use a general-purposed spring washer. Doing so may make the screws even
looser.