IAI America SSPDACR - Manual (Page 21)

1. Checking the Product
13
1.4 How to Read the Model Number
ISDB - M - A - 200 - 20 - 500 – T2 - M - B - **
*1 This maybe displayed for the manufacturing reason.
(This is not to indicate the manufacturing model code.)
<Series>
Simple dust-proof type
Aluminum-based
ISDB: Standard specification
ISPDB: High-precision
specification
Clean room type
Aluminum-based
ISDBCR: Standard specification
ISPDBCR: High-precision
specification
Iron-based
SSPDACR: High-precision
specification
Identification for IAI use only *1
<Options>
AQ : AQ seal (Standard equipment)
B : Brake
C : Creep sensor
L : Limit switch
LL : Limit switch, opposite side
LM : Synchronized specification, master axis
LLM : Synchronized specification
(sensor on opposite side, master axis)
NM : Reversed-home specification
RT : Guide with ball retention mechanism
S : Synchronized specification, slave axis
A1S : Cable exit from the left
A1E : Cable exit from the back on the left
A3S : Cable exit from the right
A3E : Cable exit from the back on the right
ST : High-precision straightness specification
(Note) Option only for High-Precision
Types (ISPDB, ISPDBCR and
SSPDACR)
VR : Piping joint for suction
Opposite installation specification
<Encoder type>
A: Absolute
I: Incremental
<Motor type>
60: 60 W
100: 100 W
200: 200 W
400: 400 W
<Lead>
4: 4 mm
5: 5 mm
8: 8 mm
10: 10 mm
16: 16 mm
20: 20 mm
30: 30 mm
40: 40 mm
<Cable length>
N: No cable
S: 3 m
M: 5 m
X : Length specification
<Stroke>
<Applicable controller>
T1: XSEL-J/K
T2: SCON
SSEL
XSEL-P/Q
<Type>
S: Small type
M: Medium type
MX: Medium type with intermediate
support
L: Large type
LX: Large type with intermediate
support