IAI America SSPDACR - Manual (Page 78)

13. Replacement/Adjustment Procedure for Stainless Sheet
70
13.2 Replacement/Adjustment Procedure
(1) Move the slider to the center of the actuator.
(2) Turn off the controller power.
(3) Remove the four affixing screws to take out the slider cover.
After removing the slider cover
(4) Use an Allen wrench of 3 mm across flats to remove the two retainer screws on the left and right and take out
the retainer plate and current stainless sheet.
(5) Affix the new stainless sheet with the retainer plate and screws.
Affix only the screws at the motor end, and keep the screws at the front side loose.
Slider
Stainless sheet retainer plate and affixing screws
Affix only the screws at the motor end, and keep
the screws at the front side loose.