IDEC FL1E SmartRelay - Manual (Page 207)

IDEC SmartRelay functions
IDEC SmartRelay Manual 193
Note
If Trg = 0 and Par = RS, the special function “Current impulse relay ” 
corresponds with the special function “Latching relay” (see Chapter
4.4.21).
4.4.23 Message texts
Short description
With the message text function block, you can configure a
message that includes text and other parameters for IDEC
SmartRelay to display in RUN mode.
You can configure simple message texts from the IDEC
SmartRelay Display. WindLGC provides an extended set of
features for message texts: bar graph representation of data,
names for digital I/O states and more. Refer to the WindLGC
documentation for information on these features.
Global Message Text Settings
You configure global parameters that apply to all message
texts from the Msg Config selections on the Programming
menu:
• Analog Time: refresh rate in milliseconds that specifies
how frequently analog inputs in message texts are
updated
• Tick time: frequency at which message texts scroll on and
off the display 
There are two ways that a message text can tick on and
off the screen: line by line, or character by character,
which are described in more detail below. A line of a text
message, or each character of a text message in turn will
tick on and off the IDEC SmartRelay Display based on
the tick time. For a message that ticks line by line, the
actual tick time is ten times the configured tick time. For
messages that tick character by character, the actual tick
time is the configured tick time.
• CharSets: The primary and secondary character sets
from which you can configure message texts. CharSet1
and CharSet2 can be any of the supported character sets
for IDEC SmartRelay: