IDEC FL1E SmartRelay - Manual (Page 40)

IDEC SmartRelay installation and wiring
26 IDEC SmartRelay Manual 
2.2.1 DIN rail mounting
Mounting
How to mount an IDEC SmartRelay base module and a
digital module onto a DIN rail:
IDEC SmartRelay base module:
1. Hook the IDEC SmartRelay base module onto the rail.
2. Push down the lower end to snap it on. The mounting
interlock at the rear must engage.
1
2
3
4
5
6
IDEC SmartRelay digital module:
3. On the right side of the IDEC SmartRelay base module/
IDEC SmartRelay expansion module, remove the
connector cap.
4. Place the digital module onto the DIN rail on the right-
hand side of the IDEC SmartRelay base module.
5. Slide the digital module towards the left until it contacts
the IDEC SmartRelay base module.