Inter-M PAC-5000 - Manual (Page 20)

DIGITAL PA COMBINATION SYSTEM
18 PAC-5000
Operating Method Operating Method
1. BEFORE SETTING STARTED THE SYSTEM
1) Put all the volumes at minimum level before inserting the power cable to a wall outlet.
2) Be sure that the speakers and input terminals are connected correctly. .
Especially, you must check up AMP output and input terminals on the rear part are correctly connected.
(Refer to Page 12.)
3) Confirm the rated power of the system and then connect the power cable to a wall outlet.
4) The lamp (RED) on the power(STANDBY) button is lit when turn ON the main power switch on the rear part.
5) When press the power button on the front part, the display window is lit and the system gets started.
6) And then adjust sound volumes with each of the input volumes and the main volume.
2. SYSTEM OPERATION
1) Simultaneous broadcasting of different 2 groups.
In BGM broadcast, this system offers two different simultaneous broadcastings to Group A zone and
Group B zone.
- Input selection per Group
Select an input you desire by using the input selection buttons (FUN.) for each of Groups.
When press the button every time, it changes in the order of TUNER > MEDIA > AUX1 > AUX2.
※ Example : Group A zone: TUNER give a broadcast, Group B zone: MEDIA (CD) give a broadcast
- Adjust main sound volumes per Group
With the mode selection buttons located on the front part, adjust properly speaker output levels per Group.
- MIC and chime broadcast
ƒU Available to give a MIC broadcasting by separating Group A and Group B.
ƒU In order to give a MIC broadcasting, you must turn ON the MIC button of Group to which it is
given.corresponding broadcast at a predefined level independent of a main sound volume position.
¢
¢
¢—
➡
PAC5000_E 2008.7.1 5:59 PM 페이지 21