Inter-M PAC-5000 - Manual (Page 8)

DIGITAL PA COMBINATION SYSTEM
6 PAC-5000
Front Panel Front Panel
1. POWER SWITCH
Connect the power plug to a wall outlet in your place and then by utilizing the button, power ON/OFF.
When the power is ON, the button LED (red) puts out, but in standby power state the button LED lights.
The main power switch locates on the rear part of the product.
2. GROUP-A / B BUTTON
The button switches on or off the whole speaker zone set by Group A and B whose initial setting values are
12 for Group A (ZONE1~12) and 12 for Group B (ZONE13~24) respectively. And you can freely reset 12
zones in each within the 24 zones.
3. NORM / EM (NORMAL / EMERGENCY) BUTTON
It is used to select the normal broadcast mode or the emergency broadcast mode. In the normal broadcast,
the green LED lights and in the emergency broadcast the red LED lights.
4. SPEAKER ZONE SELECTION BUTTON ( 1~24 )
It is used to operate speaker zones in Group A or Group B individually. When the zone switch is pressed,
the LED of the corresponding button is lit. For Group A the green LED is lit, for Group B the yellow LED is lit,
and for an emergency broadcasting the red LED is lit respectively. A zone state set up remains saved even
in the mode conversions from power ON to OFF and from normal to emergency broadcast mode.
5. SIREN BUTTON
The button is used to select and run continuous or undulating sire.
15 16 17 18 19 20 19 21
14 13 12 10 9 11 7 6 8 5 4 3 2 1
PAC5000_E 2008.7.1 5:59 PM 페이지 9