IPA Tools 9008-SE Super MUTT Standard Edition - Manual (Page 7)

7
QUICK SET-UP GUIDE
NOTE: The Super MUTT ® Deluxe is an advanced diagnostic tool designed to
eliminate guesswork and make your job easier. As a general rule, if something is
wrong with your trailer’s electrical system, the MUTT ® will beep and blink LEDs to
indicate the problem. Air brake testing is straightforward, but should be operated
only AFTER reading the instruction manual. Both Lights and Air Brakes can be
operated by remote control.
1. CHOCK ALL WHEELS BEFORE TESTING BRAKES.
2. INSTALL A FULLY CHARGED GROUP 31, 12 VOLT DC BATTERY in the battery
compartment of your Super MUTT ® Deluxe.
3. INSTALL THE ANTENNA (in the included accessories bag) into the MUTT ®
antenna jack (see Fig. 5, page 17).
4. PROGRAM THE REMOTE by holding down the large button of remote while
simultaneously turning the MUTT ® power On. Release the large button after 2
seconds. The remote control is programmed once the start-up sequence has
finished and the Ground Integrity light on the MUTT ® remains solid green. The
small button on the remote for Air Brake operation will also be programmed at
this time.
5. CHECK 7 PIN CONNECTORS on both sides of the MUTT ® before operating
to make sure the pins are spread to the proper width and greased. This ensures
a solid connection.
6. CONDITION 7 PIN CONNECTORS: Use dielectric grease on all connections to
avoid corrosion. If a bad connection exists at the terminal junction, you may get
an erroneous reading or the MUTT ® will not work properly. Make sure that you
have a solid connection in the 7 way socket (perform cable test).
7. CONNECT THE OUTPUT side of the 7 pin cable to the trailer being tested. Connect
shop air into the clean air source. Optimum test pressure is 100psi (do not exceed
120 psi). Connect the red air hose to the Emergency Side (left) Air Out connection
on the front of the MUTT ® . Then connect the blue air hose to the Service Side Air
Out connection. Finally connect each of the appropriate glad hand connectors to
the corresponding trailer connection.
8. Optimum testing pressure is 100 PSI.