KB Electronics Installs on end of KBVF - Manual (Page 4)

“The Right Control for Your Application.” 12095 NW 39 Street, Coral Springs, FL 33065-2516
Telephone: 954-346-4900; Fax: 954-346-3377
KB Electronics, Inc. www.KBelectronics.com
SIVFR Signal Isolator and Run/Fault Relay (Part No 9597) SIVFR Signal Isolator and Run/Fault Relay (Part No 9597) SIVFR Signal Isolator and Run/Fault Relay (Part No 9597) SIVFR Signal Isolator and Run/Fault Relay (Part No 9597)
Supplemental Information for Installation and Operation Manual Part No. A40264 Supplemental Information for Installation and Operation Manual Part No. A40264 Supplemental Information for Installation and Operation Manual Part No. A40264 Supplemental Information for Installation and Operation Manual Part No. A40264
(A42132) – Rev. B01 – 9/18/2006 – Z3017B01 Page 4 of 8
Figure 6
Ribbon Cable Installed on the SIVFR
1.5 MOUNTING THE SIVFR: Be sure the SIVFR PC board is properly seated and oriented in the enclosure base. The mounting holes
on the SIVFR PC board must align with the mounting holes on the enclosure base. Do not install the enclosure cover until all wiring
on the SIVFR is complete.
Align the SIVFR assembly mounting holes with the mounting holes located on the trimpot side of the KBVF heat sink. Insert the
two 6-32 X ½” combination head screws (provided), through the SIVFR assembly. Use a Philips or flat blade screwdriver to tighten
the screws and secure the SIVFR to the KBVF. Do not overtighten the screws. See Figure 7. Also see Figure 2, on page 2.
Figure 7
Mounting the SIVFR