KB Electronics KBWS-25D - Manual (Page 4)

i. SIMPLIFIED OPERATING INSTRUCTIONS
IMPORTANT – You must read these simplified operating instructions before proceed-
ing. These instructions are to be used as a reference only and are not intended to
replace the detailed instructions provided herein. You must read the Safety Warning
on page 5 before proceeding. See Application Note, Section VII, on page 18.
A. Power Connection – Connect the AC line to L1 and L2 terminals, as shown in
Figure 4, on page 13 and as described in Section IIIA, on page 13.
B. Permanent Magnet (PM) Motor Connection (Two Wire Type) – Connect the
motor armature to terminals A+ and A- as shown in Figure 4, on page 13 and as
described in Section IIIB, on page 13. On dual voltage models, be sure that
Jumper J1 is set to the corresponding motor voltage position, as described in
Section IV, on page 15.
C. Plug-In Horsepower Resistor® – Install the proper Plug-In Horsepower
Resistor® (supplied separately) according to motor current and horsepower.
See Table 3, on page 12.
D. Trimpot Settings – All trimpots have been factory set, as shown in Figure 1, on
page 8. Trimpots may be readjusted, as described in Section IX, on page 18.
E. Diagnostic LEDs – After power has been applied, observe the LEDs to verify
proper control function, as described in Section X, on page 22.
4
This product complies with all CE directives pertinent at the time of manufac-
ture. Contact the Sales Department for detailed installation and Declaration of
Conformity. Installation of a CE approved RFI filter (KBRF-300 [P/N 9484] or equiva-
lent) is required. Additional shielded motor cable and/or AC line cables may also be
required.