KB Electronics Multi Speed Board - Manual (Page 10)

B. Removing Terminal
Block TB1 from the
KBMG – Remove Terminal
Block TB1 from the KBMG
by rocking it back and forth
or using a flat blade screw-
driver to gently pry it off. The
removed terminal block will
not be used and may be dis-
carded. See Figure 9.
C. Modifying the KBMG
Finger-Safe Cover – Once
the KBMG finger-safe cover
is removed, it has to be mod-
ified to accommodate the
KBMG Multi-Speed Board.
Cut out the finger-safe cover
panel at seven (7) places as
shown in Figure 10, on page
9. Note: Some finger-safe covers may already have the cover removed.
D. Installing the KBMG Finger-Safe Cover – Once the KBMG finger-safe cover has
been modified, it can be installed onto the KBMG. Initially, use only the two (2) 5-40 X
1/4” socket head screws, using the supplied 3/32” hex key. Do not over tighten these
screws or damage may result to the KBMG finger-safe cover. See Figure 6 on page 6.
8
KBMG
Terminal Block
TB1
FIGURE 9 – REMOVING
TERMINAL BLOCK TB1 FROM THE KBMG