LevelOne WBR-6805 - Manual (Page 8)

8
1.4 The Rear Panel
The rear panel of the Wireless Router is shown below.
 LAN: Through this port, you can connect the router to your PCs and the other Ethernet
network devices.
 WAN: This WAN port is where you will connect the cable/DSL Modem, or Ethernet.

DC IN: Plug the circle end of the USB cable firmly into the rear panel of the router, and put
the other end into an electric service outlet, then the system is ready.
 WPS/Reset Button:
Click this button for once it means to start PBC configuration method, in which users can
easy setup WPS connection.
If you push the button for more than 5 seconds and then release it, the system will return to
factory default setting. In the meantime, system rewrites flash to default value and then
system reboot. Approximately 60 seconds later, the whole system parameters have returned
to factory default value. If the process has been interrupted by any reason(like power off), the
system will fail. Before perform the process, please ensure a safe operating environment!

Antenna: The function of the antenna is to enhance the wireless signal and expand the range
of signal.
Warning ： Incomplete factory setting recovery procedure will cause the Wireless Router
malfunction！If you are unfortunately in this situation, do not try to repair it by
yourself. Consult your local distributor for help!